Experts in Power factor correction and LV Switch gear upgrades
If you need more circuits and your switchboard is no longer supported by others then we can provide you with additional or replacement sections. We can provide new sections to match your existing busbar rig and give you the additional circuits you need. We can include:
Moulded Case Circuit Breakers
Air Circuit Breakers
MCCB Distribution boards
MCB Distribution Boards
Power Factor Correction
We can accommodate all of the above including various combinations and manufacturers to suit your requirements.
Where necessary we will remove a complete switchgear section and slide in a replacement. this can be useful when site conditions do not allow for a long enough shutdown to completely refurbish and refit a section.
We were looking to replace current protection units for our existing switchgear which is now fifteen years
old. We managed to contact Richard Hardy who was most helpful and visited our site along with Wayne Yeomans. Between them they
sourced the units and arranged fitting to our switchgear. All work was carried out in a very professional manner also with good backup
after work was completed.
D C Thompson
MCCB Extension section at UK food factory
Low-Height Fuse Switch Extension Section
Sections being tested in our factory
Triple tier mains / gen / bypass incomer section including complete new change-over controls installed at UK Hospital. This was carried at each end of the existing switchboard and two new oil-filled transformers supplied, fitted and cabled.